Rice Lake 520 HMI Digital Weight Indicator Installation Manual - Manual (Page 34)

Configuration 28
Level 3 Submenus EDP Port
BAUD 9600
19200
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the EDP port.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted from the EDP port.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the EDP port.
ECHO ON
OFF Allows the echo to be turned on or off.
EOLDLY 0000000
0–255 End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
HANDSHK OFF
ON Specifies whether XON/XOFF flow control characters are used.
ADDRESS 0000000
0–255 Specifies the decimal indicator address for RS-485 connections. RS-232 communications is
disabled if an address other than zero is specified for this parameter. RS-485 addresses must be
in the range 0–255.
STREAM OFF
LFT
IND Specifies whether data is streamed from the EDP port.
OFF: Data is not streamed from the EDP port
LFT (Legal-for-Trade): Data is streamed at the display update rate
IND (Industrial): Data is streamed at the A/D update rate
FORMAT DEFLT 7
DEFLT 8
CUSTOM
BUS FMT Specifies whether the serial port sends data using the default stream format (using either 7 or 8
weight digits), a custom stream format (configured in STRMFMT; see Figure 3-10 on page 34), or
is streamed to a network bus (Profibus, Remote I/O, DeviceNet). For more specific information
on CUSTOM stream format, see Table 12-5 on page 77. BUS FMT is only used with serial bus
options.
Level 3 Submenus Printer Port
BAUD 9600
19200
300
600
1200
2400
4800 Baud rate. Selects the transmission speed for the printer port.
BITS 8NONE
7EVEN
7ODD Selects number of data bits and parity of data transmitted from the printer port.
TERMIN CR/LF
CR Termination character. Selects termination character for data sent from the printer port.
ECHO ON
OFF Allows the Print Echo to be turned on or off.
EOLDLY 0000000
0-255 End-of-line delay. Sets the delay period, in 0.1-second intervals, from when a formatted line is
terminated to the beginning of the next formatted serial output. Value specified must be in the
range 0-255, in tenths of a second (10 = 1 second).
SERIAL Menu
Parameter Choices Description
Table 3-5. Serial Menu Parameters (Continued)