Rice Lake 520 HMI Digital Weight Indicator Installation Manual - Manual (Page 63)

57 520 Indicator Installation Manual
9.1.5 Normal Mode Commands
The normal mode commands (see Table 9-13) transmit data to the EDP port on demand. The SX command is valid
only in normal operating mode; all other commands are valid in either setup or normal mode.
Table 9-13. Normal Mode EDP Commands
Command Description Response Format
CONSNUM Set consecutive number 0–9 999 999
UID Set unit ID nnnnnnn (up to seven characters)
SD Set date MMDDYY, DDMMYY, YYMMDD (enter using DATEFMT
specified)
ST Set time hhmm (enter using 24-hour format)
SX Start EDP or PRN streaming OK or ?? The respective port for EDP.STREAM or
PRN.STREAM must be set to LFT or IND to use these.
EX Stop EDP or PRN streaming
DX Start streaming raw A/D counts
RS Reset system —
XA Transmit accumulator value nnnnnn UU
where nnnnnn is the weight value, UU is the units. XC Transmit count
XG Transmit gross weight in displayed units
XN Transmit net weight in displayed units
XT Transmit tare weight in displayed units
XG2 Transmit gross weight in non-displayed units
XN2 Transmit net weight in non-displayed units
XT2 Transmit tare weight in non-displayed units
XE Query system error conditions nnnnn
See Section 12.3 on page 74 for detailed information about
the XE command response format.