Rice Lake TA Series, Rice Lake Weighing Systems - Manual (Page 26)

22 RL-TA Series Operation Manual
Repeating this operation will improve the resolution of parts counting for more accurate
measurements.
5. Finish sampling.
Press the Function key to finish updating the memory.
The average sample weight is saved and the balance returns to
measurement mode.
6. Counting the number of samples.
After the average sample weight has been saved, the number of
samples put on the balance will be displayed.
Pressing the Function key toggles the display between number
of samples, average sample weight, and total weight.
☆ Hints ☆
1. The [
Sub] display that may be shown during a memory update of average unit weight indicates that you
added more than three times as many samples as the displayed number and thus the counting accuracy is
low. Do not add too many samples at a time. Gradually increase the number of samples to increase
counting accuracy.
2. If a sample is lightweight the balance may display [
Add] during a memory update of average sample
weight. This indicates that the number of samples is too small and the counting accuracy is low. [
Add]
display is turned off to improve the counting accuracy.
3.
When these indications are displayed, you can press the Function key to store the average unit weight. In
this case, however, counting accuracy is low, and a counting error may be caused.
4. When [
L -- Err] may be displayed to indicate that the average unit weight is too small for the balance to
count the samples. ([
L -- Err] will be displayed until a key is pressed.)
For more information on the minimum unit weight supported by the parts counting function, refer to
“Section 23: Specifications” on page 83.
5.
Pressing the Print key during sampling cancels the sampling.
6. The average sample weight will be stored even after the power is turned off. If you want to count
different types of samples, perform sampling again.