Rice Lake TA Series, Rice Lake Weighing Systems - Manual (Page 28)

24 RL-TA Series Operation Manual
9.2 Set a reference weight by entering a value
You can enter a reference weight in the balance, and then make the display indicate the weight percentage
(%) of a sample with respect to the reference.
1. Displaying a reference sample weight.
Make sure that the [%] sign is displayed and press and hold the
Function key for a few seconds.
(This operation may be performed with a container placed on
the balance.)
The display then blinks [
P. SEt].
The previously saved reference sample weight blinks.
2. Enter a reference weight.
Press the Zero/Tare key.
The digit farthest to the right blinks.
3. Select a number.
Press the Zero/Tare key.
Pressing the key changes the displayed number as shown
on the right.
4. Select digit places to specify a reference weight.
Pressing the Function key shifts the blinking digit to the left,
allowing you to set a higher-order digit.
If the digit furthest to the left is blinking, pressing the key
makes the digit furthest to the right blink.
5. Save the reference weight.
Press the Target key.*
(* Pressing the Print key cancels the setting of a reference
sample weight.)
6. Put a sample to weigh on the balance.
Put a sample to weigh on the balance.
The display indicates the weight percentage (%) of the sample
with respect to the reference.
Pressing the Function key toggles the display between
percentage weight and total weight.