Rice Lake TA Series, Rice Lake Weighing Systems - Manual (Page 43)

RL-TA Series Operation Manual 39
13.5.2 Set two limit values by entering values − Judge by Deviation Values −
1. Start limit value setting.
Press and hold the Target key for a few seconds.
When [
r.SEt] is displayed, release the key.
The current reference value blinks.
2. Switch to the value input screen.
Press the Zero/Tare key.
A [] blinks in the right end of the display.
3. Enter a reference weight.
Perform the same procedures as given in steps 3
and 4 in Section 13.4.2, “Set two limit values by
entering values” on page 32 to enter a reference
weight.
After the reference weight is entered, press the
Target key to save it.
4. Enter a lower limit value.
Repeat step 3 above to set a lower limit.
When you have entered the lower limit value,
press the Target key to save the value.
(When one point is set, the balance returns to
measurement mode.)
For making judgments by deviation values, enter the errors between the reference weight and the
upper and lower limits.
(Continued on next page.)