Cub Cadet SLTX1000 Series - Manual (Page 113)

CVT DRIVE AND BRAKE SYSTEM
107
Linkage: pedal tie strap
NOTE: If there is reason to remove the pedal tie strap, it
can be taken off without further disassembly of the
pedal shaft. The most likely reason for this would
be the discovery of damage to the plate or hex
bushing while making an adjustment to the ten-
sioner pulley control rod.
1. Remove the mowing deck.
2. Remove and discard the cotter pin that holds the ten-
sioner pulley control rod and the tie plate to the
“cobra-head” arm on the drive control pedal shaft.
See Figure 6.33.
3. Slip the tie strap off of the “cobra-head” arm, and
pivot it downward. See Figure 6.34.
4. Slip the tie plate off of the hex bushing, and remove
it.
5. Snap the hex bushing off of the brake pedal shaft.
See Figure 6.35.
Figure 6.33
Tensioner pulley
control rod
Cobra head
Figure 6.34
Hex bushing
Tie strap
Figure 6.35
Hex bushing