Cub Cadet SLTX1000 Series - Manual (Page 25)

Steering
19
Sector gear and steering pinion gear
If you are replacing the sector gear or steering pinion
gear, check the condition of both gears for any wear or
damage. It may be wise to replace both as a set.
1. Remove the cutting deck by following the steps
described in Chapter 8: Cutting Decks and Lift Shaft
2. Jack up the front end of the tractor and securely
place on jack stands.
3. Remove the flange lock nut securing the steering pin-
ion gear to the steering shaft using an 11/16” socket.
See Figure 3A.9.
4. Slide the steering pinion gear off of the steering shaft.
5. Lift up on the steering shaft and remove the washer.
See Figure 3A.10.
6. Push the steering shaft up through the frame of the
tractor.
7. Remove the hex bushing. See Figure 3A.11.
Figure 3A.9
Steering Pinion Gear
Flange Lock Nut
Figure 3A.10
Lift up on the steering shaft
Remove the washer
Figure 3A.11
Remove the hex
bushing