Cub Cadet SLTX1000 Series - Manual (Page 227)

Cutting Decks And Lift Shaft
221
3. Remove the two screws that secure the deck lift arm
indexing plate using a 1/2” wrench. See Figure 8.40.
4. Push the deck lift arm as far forward as it will go.
5. Remove the hair pin clip that secures the lift cable to
the lift shaft then slide the clevis pin out of the cable.
See Figure 8.41.
NOTE: With the indexing bracket loose, there should be
enough clearance to slide the clevis pin out past
the frame.
6. Disconnect the lift cable from the lift link by removing
the cotter pin.
7. Lift the cable off of the cable pulley.
8. Install the lift link cable by following the previous
steps in reverse order.
9. Test run the tractor in a safe area before returning it
to service.
Figure 8.40
Remove these
screws
Figure 8.41
Remove this pin