Cub Cadet SLTX1000 Series User Manual

Page 33

Advertising
background image

Electronic Power Steering

27

Troubleshooting the EPS (without the 725-05419 EPS tester)

The first step in troubleshooting the EPS system is to
understand how it works. See Figure 3B.4.

• A constant 12 volts is supplied by the battery

through a 40 amp fuse in the fuse box.

• The EPS is grounded through the green wire.

• The EPS senses the ignition pulses from the igni-

tion module primary windings through the yellow
wire with a white trace.

NOTE: On tractors with Kohler engines with a Digital

Spark Advance (DSA) ignition, A diode is installed
to protect the ignition module from any stray volt-
age that may come from the engine shut down cir-
cuits. A white wire carries a clean spark signal to
the EPS to turn it on. See Figure 3B.5.

• Once the EPS determines that the engine is run-

ning (by sensing the ignition pulses from the igni-
tion coil) it will turn on.

• The EPS will power the EPS motor as it senses

input from the steering wheel.

To troubleshoot the EPS assembly:

1

Check the 40 amp fuse in the fuse box.
See Figure 3B.6.

NOTE: If the fuse is blown, check for a short in the red

wire that goes to the EPS assembly before replac-
ing the fuse.

The technician needs to determine if there is a mechan-
ical bind in the steering system or an EPS issue. The easi-
est way to rule out a binding steering system is to:

2.

Remove the steering pinion gear by following the
procedures described in Chapter 3: Steering.

3.

Start the engine.

4.

Operate the steering wheel.

• If the steering wheel now moves freely, the issue is

downstream of the pinion gear. The most likely
suspect would be axles frozen to the pivot bar.

• If the steering wheel is still hard to operate, isolate

the problem to either the EPS assembly or the cir-
cuits that go to the EPS assembly.

NOTE: To protect the EPS module, it will turn off if the

steering input is held at a hard stop for more than 2
seconds. The EPS will turn back on once the input
is released from the hard stop.

,JQLWLRQPRGXOH

*5281'

0$*1(72

%$77(5<

Figure 3B.4

,JQLWLRQPRGXOH

*5281'

0$*1(72

%$77(5<

(QJLQHVKXW
GRZQFLUFXLWV

Figure 3B.5

Figure 3B.6

40 amp fuse

Advertising
This manual is related to the following products: