Cub Cadet SLTX1000 Series - Manual (Page 48)

LTX Tractors
42
Removal procedures for fenders are very similar on all
variants. Where necessary, notes will be included to cover
slight differences in procedures.
1. Seat removal: It is necessary to remove the seat
before removing the fenders, primarily because of
the seat safety switch connection.
1a. Tilt the seat up, and disconnect the negative
battery cable. See Figure 4.14.
NOTE: The seat slides in three “T” slots in the seat
bracket. A single bolt threads into one of the
forward bosses on the seat base, locking it
into the slots. On installation, tighten the bolt
to a torque of 60-80 in-lbs. (7-9 N-m).
1b. Remove the locking bolt using a 9/16” wrench.
See Figure 4.15.
1c. Slide the seat forward to the end of its travel,
then lift it up to disengage the slide blocks
from the “T” slots. See Figure 4.16.
1d. Disconnect the seat safety switch from the
harness plug to remove the seat.
1e. Lift the seat off of the tractor.
Figure 4.14
cable
battery
Negative
Figure 4.15
Locking bosses
Bolt
Figure 4.16
Seat safety switch
Harness plug