Cub Cadet SLTX1000 Series - Manual (Page 124)

LTX Tractors
118
Drive belt replacement
NOTE: The variable speed pulley system that drives
this tractor counts on interplay between two
belts:
• If one belt fails, replace both belts. One new
belt and one partially worn belt will not work the
same as two new belts.
• Do not use any belt other than the correct Cub
Cadet part number belt. This drive system
counts on an unusual cross-section shape of
the belts. Use of a wrong belt will very likely
cause the tractor not to drive properly.
• Check the tensioner pulley control rod adjust-
ment after replacing belts.
1. Remove the mowing deck.
2. Set the park brake to release belt tension.
3. Remove the battery and battery tray by following the
procedures described in Chapter 4: Body Panels.
See Figure 6.58.
4. Remove upper (rear) drive belt:
4a. Release the lateral spring that provides force
for the tension idler pulley. See Figure 6.59.
! CAUTION ! CAUTION
The battery will be removed in this procedure. Review the Operator’s Manual and Chapter 7:
Electrical System for important safety information about handling batteries before proceeding.
Figure 6.58
Figure 6.59
Lateral
spring