Cub Cadet SLTX1000 Series - Manual (Page 96)

LTX Tractors
90
19c. The large return-to-neutral spring can be
unhooked from the return-to-neutral cam.
See Figure 5.84.
19d. Remove the belt keeper from the top of the
transaxle using a phillips head screwdriver.
See Figure 5.85.
20. Installation notes:
20a. After repairs are done, and the transmission is
re-filled with fluid, it may be “bench purged” if
the technician has a way to drive the input
shaft using a 1/2” drill motor.
20b. Check adjustment of the brake before installing
the transaxle.
20c. Position the large return-to-neutral spring on
the return-to-neutral cam before lifting the tran-
saxle back into the tractor.
20d. Connect both ends of the brake actuator spring
before lifting the transaxle back into the tractor.
20e. Coat the Double-D axle shaft with a high quality grease or anti seize compound before installing the
wheels.
20f. The spring in the bypass linkage hooks downward into the transmission release rod.
20g. Tighten fasteners according to the accompanying torque table.
20h. Fully purge the drive system before operating the tractor.
20i. Operate and test the drive system, brake system, and all safety features before returning the tractor to
service.
Figure 5.84
Small r-t-n spring
r-t-n cam
Large r-t-n spring
Figure 5.85
Belt
keeper
Screw