Cub Cadet SLTX1000 Series - Manual (Page 84)

LTX Tractors
78
8b. With electric PTO, there are two fasteners:
See Figure 5.52.
8c. One bolt holds the belt keeper to the frame, to
the left side of the engine.
8d. A nut holds the belt keeper to the right-side
frame channel.
NOTE: The electric PTO belt keeper incorporates
an anti-rotation bracket for the PTO clutch.
9. Lower the engine pulley to remove the belt; manual
PTO.
9a. Remove the bolt that holds the engine pulley
to the crankshaft using a 5/8” wrench.
9b. Slide the pulley off of the engine crankshaft.
The belt will clear the belt keepers as the pul-
ley comes down. See Figure 5.53.
9c. Remove the belt.
10. Lower the engine pulley to remove the belt; electric
PTO.
10a. Disconnect the PTO clutch electrical plug from
the harness. See Figure 5.54.
Figure 5.52
Nut
Belt keeper
Bolt
Figure 5.53
Figure 5.54
Wire harness
PTO clutch plug