Cub Cadet SLTX1000 Series User Manual
Page 26
LTX Tractors
20
8.
Remove the drag links from the sector gear.
9.
Remove the six screws that secure the steering
plate to the frame. See Figure 3A.12.
10.
Remove the steering plate.
11.
Remove the hex cap screw, shoulder spacer and
hex nut in the middle of the sector gear using two 9/
16” wrenches. See Figure 3A.13.
NOTE: Note the order the spacers and washer were
removed so that they can be installed prop-
erly. See Figure 3A.14.
12.
Remove the bolt that the sector gear pivots on using
two 9/16” wrenches. See Figure 3A.13.
NOTE: When installing the sector gear, coat the
sector gear and the steering plate with a
high quality lithium grease.
13.
Install the steering and steering pivot gears by fol-
lowing the previous steps in reverse order.
14.
Perform a wheel alignment by following the steps
described in the steering alignment section of this
chapter.
15.
Test run the tractor in a safe area before returning it
to service.
Figure 3A.12
Remove these screws on each side
Figure 3A.13
sector gear
Steering plate
Figure 3A.14