Cub Cadet SLTX1000 Series - Manual (Page 121)

CVT DRIVE AND BRAKE SYSTEM
115
5. Remove the nut that holds the ball joint end of the
tensioner pulley control rod to the tensioner pulley
bracket using a 1/2” wrench. See Figure 6.51.
6. Note the belt routing, then slip the drive belt off of the
two pulleys on the tensioning bracket.
7. Remove the nut and bolt that hold the belt tensioner
pulley bracket to the frame using a pair of 9/16”
wrenches. See Figure 6.52.
8. Maneuver the belt tensioner bracket assembly to
clear the belt, and remove it from the tractor.
See Figure 6.53.
NOTE: The bracket assembly pivots on the bolt that
passes through the fixed flat-sheave idler pulley.
Figure 6.51
Figure 6.52
Figure 6.53