Cub Cadet SLTX1000 Series - Manual (Page 58)

LTX Tractors
52
4. Disconnect the harness plugs from the following
electrical devices under the dashboard:
See Figure 4.41.
• Hour meter
• Key switch
• RMC module
• PTO switch, if so equipped
5. Use a phillips head screwdriver to remove the throt-
tle control grip. See Figure 4.42.
6. Carefully peel-off the throttle control label.
• Gentle application of heat will help loosen the
adhesive.
• Use wax paper to preserve the adhesive.
7. Remove the two Torx TM head screws that hold the
throttle control to the dash panel using a T-27 driver.
See Figure 4.43.
Figure 4.41
Hour meter
RMC Module
Key switch
PTO switch
Figure 4.42
Throttle grip
Throttle control
label
Figure 4.43