Cub Cadet SLTX1000 Series - Manual (Page 73)

HYDRO. DRIVE AND BRAKE SYSTEM
67
Pedal shaft assembly removal
NOTE: Confirm that the parking brake is released before
starting work.
1. Remove the mowing deck.
2. Remove the fenders, as described in the body panels
chapter of this manual.
3. Disconnect the rod that joins the arm at the left side
of the brake/clutch shaft to the drive belt tensioner
pulley bracket. See Figure 5.22.
• Remove and discard the cotter pin to disconnect
the rod.
4. Remove the locking clip that holds the travel limit pin
in place.
5. Withdraw the travel limit pin. See Figure 5.23.
6. Unhook the clutch/brake pedal return spring.
See Figure 5.24.
Figure 5.22
Clutch/brake shaft Rod
Figure 5.23
Travel limit pin
Latch plates
Figure 5.24
Clutch/brake pedal
return spring
Hooks to clutch/brake
latch plate
Hooks to frame