Cub Cadet SLTX1000 Series - Manual (Page 49)

Body Panels
43
1f. The seat adjuster lever and spring will come
easily off the bottom of the seat.
See Figure 4.17.
• The lever is located by a tab that fits into a slot on
the bottom of the seat.
• The spring fits into a toroidal (doughnut shaped)
recess in the bottom of the seat.
1g. To remove the seat safety switch: squeeze the
tabs on the side of the switch, and push it into
the seat base. See Figure 4.18.
1h. Slide the switch to the wider end of the hole in
the seat base, and pull it out.
2. Remove the battery and tray:
NOTE: Battery tray removal provides easy access to the
following service points:
• Fluid check point on hydrostatic transaxles.
• Electrical: Solenoid, main fuse, battery cables
• Drive belt inspection
• Deck lift linkage inspection
2a. Disconnect the positive battery cable from the
battery (the negative battery cable was discon-
nected in an earlier step). See Figure 4.19.
Figure 4.17
Correct spring location
Seat adjuster lever
Figure 4.18
1 Push in
2 slide
forward
Figure 4.19
Positive cable
Negative
cable
Hold down