Cub Cadet SLTX1000 Series - Manual (Page 260)

310-0510 IHT 22
INPUT SHAFT
Figure 14. Input Shaft Assembly
12
Refer to Figure 14.
DISASSEMBLY
1. Remove the brake assembly and bypass
arm. See page 16.
2. Remove the control arm and friction pack.
See page 17.
3. Drain the oil from the transaxle. See page
10.
4. Remove the side housing. See page 19.
5. Remove the seals in the side housing. See
page 18.
6. Remove the axle shaft, differential and re-
duction gears. Refer to page 20.
7. Remove the motor shaft and bypass rod.
See page 21.
8. Remove the retaining ring (12) and shaft
seal (13). Discard the seal.
9. Remove the washer (11), input shaft as-
sembly (9,10 and 14), block thrust washer
(56) and block spring (55).
INSPECTION
1. Inspect the input shaft components for wear
or damage.
ASSEMBLY
1. Install the block thrust washer (56) and
spring (55) onto the input shaft (9).
2. Ensure that the pump block is aligned con-
centrically with the center section running
face.
3. Insert the input shaft (9), with bearing (14)
and retaining ring (10), into the pump block
assembly. NOTE: Do not force the shaft and
bearing as damage may occur. If alignment
is correct the shaft assembly will fit into
place.
4. Install the washer (11), seal (13) and retain-
ing ring (12).
5. Install the motor shaft & bypass rod. See
page 21.
6. Install the axle, differential & reduction
gears. Refer to page 20.
7. Install the side housing. Refer to page 19.
8. Install new seals in the side housing. See
page 18.
9. Fill the transaxle with oil. See page 10.
10. Install the control arm and friction pack.
See page 17.
11. Install the brake assembly and bypass arm.
See page 16.
11
14
55
13
10
9
56