Cub Cadet SLTX1000 Series - Manual (Page 209)

Cutting Decks And Lift Shaft
203
4. Pull the deck pins on both sides and rotate them to
keep them out. See Figure 8.5.
NOTE: The 50” and 54” decks will have an addition stabi-
lizer link on the back of the deck. Disconnect it by
removing the bow tie clip. See Figure 8.6.
5. Remove the click pin and washer that secures the
front lift rod to the deck and slide the rod away from
the deck. See Figure 8.7.
6. Raise the deck lift lever to the highest setting.
7. Slide the deck assembly out to the right.
8. Install the deck by following the above steps in
reverse order.
NOTE: The deck is easier to install if the front edge is sup-
ported by a length of 2”x4” lumber. This brings the
front hanger closer to the horizontal position. The
closer the front hanger is to horizontal, the further
back the deck can move to connect to the “J” pins
in the rear of the deck to the lift links.
Figure 8.5
Pull and rotate the deck pin
Figure 8.6
Rear stabilizer link
Figure 8.7
Remove this click pin