Hardy HI 6300 Series User Manual
Weight processor hi 6300 series
Advertising
Table of contents
Document Outline
- Weight Processor
- HI 6300 Series
- User’s Guide
- Contents
- Overview
- Specifications
- HI 6300 Installation
- Network Configuration
- Ethernet TCP/IP Network Configuration
- LAN Connection
- If the DHCP service fails, the instrument will default to the Fixed IP address after a power cycle. If the DHCP service is repaired, the instrument will revert back to using the DHCP IP address.
- DHCP Configuration Using the Front Panel
- Direct Connect Hardware
- Windows PC Configuration
- Windows 2000
- Windows XP
- Windows 7
- Direct Connect Configuration - HI 6300 Series Instrument
- Ethernet-UDP
- Modbus-RTU (over RS-485)
- Communications Parameters for the HI 6310 Only
- Chapter 5
- Instrument Configuration
- Using the Home Page to set Parameters
- Using the Front Panel Display Menus to Set Parameters
- Front Panel Display
- The Five Button Command Cluster
- Using the Mode, Zero, and Tare buttons
- Commands and Parameters
- Calibration Menu
- Hard Cal Commands and Parameters
- Communication Menu
- Modbus-RTU Commands and Parameters
- Printer Command Parameters
- USB Memory Stick Parameters
- 4-20 mA Communications Commands and Parameters
- Diagnostics Parameter Menu
- Display Parameter Menu
- Operations Parameter Menu
- Security Parameter Menu
- Setup Parameter Menu
- Chapter 6
- Calibration
- Operation
- Getting Started
- Mode Button
- Zero Operation
- Tare Operation
- Auto Mode Tracking – Disabled (Default)
- Auto Mode Tracking – Enabled
- If the instrument is in NET mode when the ZERO command is sent over communications, the display will automatically switch to showing GROSS mode after the ZERO command is sent.
- Count Operations
- Split Screen Mode
- Chapter 8
- Getting Started
- Security
- Chapter 9 Troubleshooting
- Disassembly and Reassembly Notes, Warnings & Cautions
- Error Messages
- Trouble Shooting Using Integrated Technician (IT®)
- Weight and Voltage ALL
- General Troubleshooting Flow Chart Index
- A - Guideline Instability: Electrical and Mechanical review.
- A1. Checking for Unstable Components in a Weighing System
- B. Guidelines for Electrical, Mechanical or Configuration Issues
- B1 - Guidelines to Verify Electrical Installation
- B2 - Guidelines to Verify Mechanical Installation
- B3 - Guidelines to Verify Configuration/Filter Settings to Improve Stability
- C - Integrated Technician and Stability Test Overview
- E Testing for Non-Return to Zero (System with IT Summing Card.)
- F. Verify Individual Load Sensor Millivolt Output readings
- G- Calibration Errors When Performing the Calibration
- H. Mechanical Installation
- J- Electrical Inspection
- K - Installation Check Points
- M. Weight Processor’s Front Display is Blank or Locked
- N. Analog Out (HI 6310 Only)
- Tests and Diagnostics
- System and Load Cell Tests
- Appendix A Communications I/O Table
- Index