Hardy HI 6300 Series - Manual (Page 52)

44 Chapter 5
•
•
•
•
•
•
The CONFIG Menu Structure
To configure and setup the HI 6300 series instrument press the CONFIG button. To enable
the user to continue to monitor the process the display the weight, mode, and zero symbol
are reduced and placed in the top right hand corner.
A submenu list is provided on the left hand side, with the item that would be selected
by highlighted and identified by the ♦ symbol.
The numeric or alphanumeric value for the selected item is display in the area shown as --
--- Value ----- in the above illustration, along with help text for the item selected.
If more than five item are in the submenu list, use the UP/DOWN button to scroll through
the submenu list. To select the item from the submenu list press the RIGHT or ENTER key.
Entering Numeric and Alphanumeric Values
At the lowest level of the menu hierarchy the user may need to enter a numeric or which
could represent a tolerance or an Ethernet IP address or an alphanumeric value for entering
a user ID or security password.
When a parameter value is selected, either the current value is displayed or a 0. In either
case a flashing underscore is generated under the least significant digital or character.
The LEFT and RIGHT buttons move the cursor left and right within the numeric value
or character set. In the following three number examples the cursor starts under the 300
value, the LEFT button moves the cursor under the 2000 value in example 2, and in
example 3 the RIGHT button moves the cursor under the 40 value.
Example 1: 12345.01
Example 2: 12345.01
Example 3: 12345.01