Hardy HI 6300 Series - Manual (Page 111)

Operation 101
•
•
•
•
•
•
2. The displayed weight mode may also be changed at any time by pressing the
MODE button on the front panel display or by sending the DISPLAY
MODE command over communications.
3. Sending the TARE AMOUNT=0.0000 command will remove the TARE
weight from memory and cause the displayed weight mode to automatically
switch to display the GROSS weight. (AUTO MODE TRACKING DOES
NOT FUNCTION WHILE IN COUNT MODE)
4. The ZERO button only functions on the front panel display when the
instrument is in GROSS mode.
a. If an operator presses ZERO button while in NET mode, the display
will message the user “ZERO FAIL - CHANGE TO GROSS
MODE TO USE ZERO SCALE”
6. The ZERO command functions in both NET and GROSS modes when sent
over communications.
If the instrument is in NET mode when the ZERO command is sent over
communications, the display will automatically switch to showing GROSS mode after
the ZERO command is sent.
Count Operations
Available on the HI 6310 instrument only
On the HI6310 series instrument display, select the Operations menu and use the UP or
DOWN button to select the Piece Count submenu. Select Count Enable to allow the option
of running the instrument in count mode. Piece Count can be displayed on the main screen
by pressing the MODE button and cycling through to the count mode: GROSS > NET >
COUNT >