Hardy HI 6300 Series - Manual (Page 29)

Installation 21
•
•
•
•
•
•
Step 2. Disable the cable assembly provided, and replace the original cable with the desired
cable length (not provided--up to 100 ft (30.48 meters)). Build the cable assembly
using the instructions above for Making Longer Display Interface Cables on page
13.
Step 3. Connect the front panel to the newly assembled display cable
Step 4. Push the screw rods and cable assembly though the holes in the gasket.
Step 5. Slide the screw rods through the panel until flush with the surface
Step 6. Using the washers and nuts supplied, tightened the nuts onto the screw rods. Tighten
the nuts enough to completely compress the gasket for IP65 compliance
Step 7. Connect the cable assembly to the HI 6300 series instrument
Finished Remote Display Mount Assembly
Blind Unit (No display)
The front display is not necessary for the HI 6300 series instrument to operate as a scale
controller. Blind units can be fully configured using the Web browser communication.