Hardy HI 6300 Series User Manual
Page 161
Communications I/O Tabl;es
151
•
•
•
•
•
•
•
6: WEIGHT SAMPLE CMD: Write a #6 to the command register to run the Weigh
Sample command to set up the calibration of the Counts (if enabled).
•
Status Error code 1 (motion)
•
Status error code 2 (A/D error)
•
0x64 (100 decimal): CAL LOW CMD. Write a 0x64 hex to the command register to
perform the low step of a traditional calibration. The status register will read 0 if this
command succeeds:
•
Calibration_Fail 1
•
Calibration_Fail_Motion 3
•
Calibration_Fail_Adc_Error 4
•
0x65 (101decimal): CAL HIGH CMD. Write a 0x65 hex to the command register to
perform the high step of a traditional calibration.
•
Calibration_Fail 1
•
Calibration_Fail_Motion 3
•
Calibration_Fail_Adc_Error 4
•
HardcalFailCounts 8: not enough counts between hard cal hi and hard cal lo
•
0x66 (102 decimal): C2 CAL CMD. Write a 0x66 hex to the command register to
perform a C2 calibration.
•
Calibration_Fail 1
•
Calibration_Fail_Motion 3
•
Calibration_Fail_Adc_Error 4
•
Calibration_Fail_Noc2 5
•
Calibration_Fail_C2capeq 6
•
•alibration_Fail_C2clones 7
•
0x1000 (4096 decimal): WRITE INTEGER CMD. Set the value of an integer
parameter. Write 0x1000 in the command register 0, the parameter ID number in
registers 2, 3 and the desired value in registers 4, 5.
• No Error Codes
•
0x1001 (4097 decimal): WRITE FLOAT CMD. Set the value of a floating point
parameter. Write 0x1001 in the command register 0, the parameter ID number in
registers 2, 3 and the desired float value in registers 4, 5.
•
Failure 1
•
TooHigh -1 : value is above legal limit
•
TooLow -2 : value is below legal limit
•
ErrorNotFound 0x8000 : parameter id not found