Hardy HI 6300 Series - Manual (Page 26)

18 Chapter 3
•
•
•
•
•
•
Wall Mount
Wall Mount Assembly exploded from the front with optional mounting kit
To wall mount the HI 6300 series instrument, the display and weight processor need to be
assembled; then the assembled instrument can be mounted onto the wall.
Step 1. Connect and hand tighten the four screw rods into the front panel display
Step 2. Connect the NEMA 4X front panel display cable assembly
Step 3. Push the screw rods and cable assembly though the holes in the gasket.
Step 4. Position the enclosure with the connectors pointing downwards
Step 5. Align the screw rods with the holes in the enclosure
Step 6. Connect the cable assembly
Step 7. Slide the enclosure onto the screw rods until flush with the gasket
Step 8. Using the washers and nuts supplied, tightened the nuts onto the screw rods