Altera SoC Embedded Design Suite - Manual (Page 120)

Figure 4-79: Enable Trigger Out to HPS
6. In Signal Tap II, configure the Trigger in to be disabled by setting its pattern to Don't Care. In this
scenario we do not want the HPS to trigger FPGA.
Figure 4-80: Disable SignalTap Trigger in
7. In Eclipse debugger, let the Linux kernel continue running, by pressing the green Continue button or
pressing F8.
8. In SignalTap II, press the Run Analysis button to arm Signal Tap:
Figure 4-81: Run Analysis
ug-1137
2014.12.15
FPGA Triggering HPS Example 4-101
Getting Started Guides Altera Corporation
Send Feedback