Altera SoC Embedded Design Suite User Manual
Page 93
Advertising
Figure 4-48: Configure Connection
4. Click on the Debugger and perform the following steps:
a. Select option Connect Only for Run Control
b. Check Execute debugger commands check box
c. Add the
debugger
commands to stop cores and load image symbols for the Linux executable, as
shown in the following figure
d. Add the path to the Linux source files on the host machine to allow the debugger to locate them
4-74
Debugging the Kernel
ug-1137
2014.12.15
Altera Corporation
Getting Started Guides
Advertising