Altera SoC Embedded Design Suite - Manual (Page 82)

To run the sample application, perform the following steps:
1. In the Eclipse IDE, click Run > Debug Configurations... to open the Debug Configurations dialog
box.
2. In the Connection tab in the Debug Configurations dialog box, ensure the selected target is Altera >
Cyclone V > Bare Metal Debug > Debug Cortex-A9_0 via Altera USB-Blaster.
3. Under Connections tab, click Browse to select the USB Blaster connection.
Figure 4-40: Debug Configurations
4. In the Select Debug Hardware dialog box, select the desired USB Blaster and click OK.
ug-1137
2014.12.15
Running the Hardware Library Sample Application 4-63
Getting Started Guides Altera Corporation
Send Feedback