CIRCUTOR PowerStudio Series - Manual (Page 6)

PowerStudio
6 User Manual
1.- ACCESS VIA THE POWERSTUDIO CLIENT
The software has a client application that will allow users to access SCADA screens, reports
and to display instantaneous values being measured by devices either locally or through a remote
connection. Graphs of the values recorded by the devices can also be prepared and listings accessed,
events can be viewed, device status can be displayed, etc. Similarly, this client is available as an
embedded applet on the application's webpage.
1.1.- WEB SERVER
The communications engine acts as a Web server configured in port 80 by default. To properly
configure the Web server review the ‘User manual’.
If user authentication is enabled, all access restrictions to device value screens, SCADA
screens, etc., will be applied to the remote user application trying to access them, either through the
client provided, the embedded client application in the webpage such as a Java applet or the HTML5
client.
The appearance of the PowerStudio Client when run as a Java client application and as an
embedded client in an applet in the application webpage and as a HTML5 client is shown below.
Java Client application