TabletKiosk Sahara Slate PC i575/i535 - Manual (Page 129)

Chapter 06: Upgrading Your Sahara Slate PC 103
Refer to the following instructions and illustrations for informa-
tion on how to upgrade your computer’s memory modules. Be
sure to follow the procedures in the previous section, Before you
Begin ANY Upgrade Procedure.
1. Turn off your Tablet PC, turn it over and place it face down
on a solid, flat surface. Be careful not to place it on some-
thing rough that could damage the LCD display.
2. Locate the RAM module
compartment in the up-
per right quadrant of the
back panel of the system
(refer to the section Back
View in the Touring Your
Sahara Slate PC chapter
to identify this compart-
ment). Remove the two
(2) screws that secure
the vented RAM module
compartment cover (use
a #1 Philips head screw
driver).
3. Lift the cover from the
edge where the screw
holes are located to
remove it and set it aside.
Inside are the two (2)
RAM slots. Depending
upon your system’s
configuration, it will be
populated with one or
two existing SODIMM
modules.
If there is only one module installed, go on
to step 6 to insert a second module.