TabletKiosk Sahara Slate PC i575/i535 User Manual
Page 132
106
Chapter 06: Upgrading Your Sahara Slate PC
Your Sahara Slate PC comes with a data storage drive that is
easy to replace. Before installing a new HDD or SSD, be sure to
back up all of the files on your existing drive. You will also need a
bootable Windows installation disk or a full disk backup of your
existing drive in order to restore your system.
Refer to the following instructions and illustrations to upgrade
your computer’s data storage drive. Be sure to follow the
procedures in the previous section entitled Before you Begin
ANY Upgrade Procedure.
1. Turn off your computer, turn it over and place it face down
on a solid, flat surface. Be
careful not to place it on
something rough that
could damage the LCD
display.
2. Locate the HDD/SSD
compartment near the
center of the Tablet PC
just below the docking
connector (refer to the
section Back View in the
Touring Your Sahara Slate
PC chapter to identify this
compartment). Remove
the four (4) screws that
secure the compartment
cover (use a #1 Philips
head screw driver). Lift
the cover away to expose
the drive.
3. The drive is held securely
in place by four (4) Philips
head screws. You’ll need
to remove them in order
to replace the drive.
Remove the four Philips head screws
marked above that hold the drive in place.