Super Systems 9120 with TS - Manual (Page 19)

SSi 9120 Touchscreen Interface
4586 – 9120 With Touch Screen Interface Page 19 of 80
4800 28800 115200
9600 38400
Host 485 Mode
This will allow the user to set the Host 485 mode.
This setting is fixed to Modbus for the
Touchscreen .
Host 485 Address
This will allow the user to set the Host 485 address. The range is 0 to 249.
Slave 1 Baud
This will allow the user to set the Slave 1 baud rate.
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Slave 1 Mode
This will allow the user to set the Slave 1 mode. The options are: MMI, Modbus master,
Yokogawa, or Modbus host.
Slave 2 Baud
This will allow the user to set the Slave 2 baud rate.
The options are:
1200
14400 57600
2400 19200 76800
4800 28800 115200
9600 38400
Slave 2 Mode
This will allow the user to set the Slave 2 mode. The options are: MMI, Modbus, ADAM, SSi
Analog Input Board, or Yokogawa.
IP Address
This option will allow the user to modify
the IP address of the
9120 Instrument
only. The address must be supplied in a
999.999.999.999 format, or it will not be
accepted. Contact Super Systems at 800-
666-4330 or your IT department before
changing any of the IP addresses. Note –
Communications may go down once the IP
address has been changed and before the
rest of the settings, i.e. the
Configuration
menu Communication Setup menu,
have been updated.