Super Systems 9120 with TS - Manual (Page 51)

SSi 9120 Touchscreen Interface
4586 – 9120 With Touch Screen Interface Page 51 of 80
Slave 2 SP
Input 3 Value
Remote Setpoint Hysteresis
This option will allow the user to enter the remote setpoint hysteresis. The range is 0 to 9999.
Minimum temp/pump run
This option will set the minimum temperature for the pump to run, if that feature is used. A 0
value will disable the minimum temperature feature.
Note: The furnace that is being sampled
must have its temperature connected to input 3 for the pump minimum temperature feature to
work
. The range is 0 – 9999.
Input 1
This value will display the Input 1 type. This value cannot be changed from this screen.
Input 2
This value will display the Input 2 type. This value cannot be changed from this screen.
Input 3
This value will display the Input 3 type. This value cannot be changed from this screen.
Loop 1 PV
This value will display the Loop 1 PV type. This value cannot be changed from this screen.
Loop 2 PV
This value will display the Loop 2 PV type. This value cannot be changed from this screen.
Communications Setup
Communications Setup is the
communications definitions for the
controller. Please contact Super
Systems Inc. for more information
regarding port setup. It is
strongly
recommended that none of the
settings be modified without
technical support from Super
Systems Inc. Clicking on any of the
values will display an input box that
will allow the user to modify the
current settings.
Host 232 Baud
This will allow the user to set the
Host 232 baud rate.
This must be
set to 19200 for the
Touchscreen
.
The options are:
1200
14400 57600