Super Systems 9120 with TS - Manual (Page 58)

SSi 9120 Touchscreen Interface
4586 – 9120 With Touch Screen Interface Page 58 of 80
O2 Exponent Range
This will set the exponent range for Oxygen. The range is 0 – 10.
Relay Assignments
Relay 1 – Relay 8
This value will display what the relay is
assigned as. The value cannot be changed
from this menu option.
Note – Only some of the relay assignments
can be modified depending on the PVT
type
.
This screen will display a description of the
eight relay assignments. Most of the relay
assignments are fixed in the unit. Relay 1
is the loop 2 control relay. Relay 2 is the
input 2 high limit relay. Relay 3 is the loop
1 increase relay. Relay 4 is the loop 1
decrease relay. Relay 6 is the probe burnoff relay. Relay 8 is the any alarm relay. Relay 7 is the
only relay that can be assigned. If the assignment can be modified, the user will have following
options:
Loop 1 Fwd
Event 3 Burnoff
Loop 1 Rev Event 4 IN1 Relay SP A
Loop 2 Fwd Event 5 IN1 Relay SP B
Loop 2 Rev Event 6 IN1 Relay SP C
Loop 3 Fwd Event 7 IN2 Relay SP A
Loop 3 Rev Event 8 IN2 Relay SP B
Programmer Alarm Event 9 IN2 Relay SP C
Alarm 1 Event 10 IN3 Relay SP A
Alarm 2 Event 11 IN3 Relay SP B
Alarm 3 Event 12 IN3 Relay SP C
Event 0 Event 13 Alarm Combination
Event 1 Event 14 N/A
Event 2 Event 15
The Alarm Combination option will enable the
checkboxes on the screen for selection. Any or all
of the options can be selected: Programmer
Alarm, Alarm 1, Alarm 2, Alarm 3, or T/C
Check.