First start, W61pc first start – Wavecom W61PC V7.5.0 User Manual
Page 29
WAVECOM Decoder W61PC/LAN Manual V7.5
First start
19
First start
W61PC First Start
After the software and the W61PC card have been successfully installed, the decoder program can
be started either from the WINDOWS Start menu or by double-clicking the program icon on your
desktop.
Proper operation of the decoder is indicated by the WAVECOM Server Control icon in the Windows
system tray. If the traffic light in the icon is green, then the server is operating normally. You may
also move the mouse over the icon and check that you get this status message: WAVECOM
Server (running).
The first time the software is used after the installation, you will have to set the decoder device
manually. From the menu bar, go to Configuration. A drop-down menu will appear. Click on the
W61PC Card… menu item. A setup window appears.
Select a device number and click Done to save the entry. If you require more details regarding
remote connections and connection parameters then see “
” on page 43.
The decoder is now ready for use. Apply a signal to the selected input (from a receiver) or from a
played back file.
From the HF-Modes, VHF/UHF-Modes or Satellite menus, a mode may be selected, e.g.,
PACTOR-II if a PACTOR-II signal is played back.