H3C Technologies H3C S10500 Series Switches - Manual (Page 101)

90
Step Command Remarks
2. Enable SNMP
notifications for the zone
module.
snmp-agent trap enable fc-zone
[ activation-completed |
defaultzone-change |
hardzone-change | merge-failed |
merge-succeeded ] *
By default, SNMP notifications for
the zone module are disabled.
Displaying and maintaining FC zones
Execute display commands in any view and reset commands in user view.
Task Command
Display zone alias information.
display zone-alias [ [ name zone-alias-name ] vsan
vsan-id ]
Display zone information. display zone [ [ name zone-name ] vsan vsan-id ]
Display zone set information. display zoneset [ [ name zoneset-name ] vsan vsan-id ]
Display information about the active zone set. display zoneset active [ vsan vsan-id ]
Display parent information for a zone member.
display zone member { fcid fcid | pwwn pwwn |
zone-alias zone-alias-name } [ vsan vsan-id ]
Display the running status and configuration of an FC
zone.
display zone status [ vsan vsan-id ]
Display zone packet statistics. display zone statistics [ vsan vsan-id ]
Clear zone packet statistics. reset zone statistics [ vsan vsan-id ]
FC zone configuration example
Network requirements
As shown in Figure 27 , all nodes have registered with the switches.
Configure access control in VSAN 1 to meet the following requirements:
• Server A cannot access any disk but might need to subsequently.
• Server B can access Disks A, B, and C.
• Server C can access Disks B and C.
• Servers cannot access each other.