H3C Technologies H3C S10500 Series Switches - Manual (Page 119)

108
[Transit-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10
# Configure interface Ten-GigabitEthernet 1/0/2 to operate in FCF mode.
[Transit-Ten-GigabitEthernet1/0/2] fip-snooping port-mode fcf
[Transit-Ten-GigabitEthernet1/0/2] quit
2. Configure the FCF switch:
# Configure the switch to operate in advanced mode, save the configuration, and reboot the
switch. (Skip this step if the switch is operating in advanced mode.)
<FCF> system-view
[FCF] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
[FCF] save
[FCF] quit
<FCF> reboot
# Configure the switch to operate in FCF mode.
<FCF> system-view
[FCF] fcoe-mode fcf
# Set the FC-MAP value to 0x0EFC01.
[FCF] fcoe fcmap 0efc01
# Create VSAN 10.
[FCF] vsan 10
[FCF-vsan10] quit
# Create interface VFC 2.
[FCF] interface vfc 2
# Configure the mode of VFC 2 as F.
[FCF-vfc2] fc mode f
# Assign VFC 2 to VSAN 10.
[FCF-vfc2] port trunk vsan 10
# Bind VFC 2 to interface Ten-GigabitEthernet 1/0/2.
[FCF-vfc2] bind interface ten-gigabitethernet 1/0/2
[FCF-Vfc2] quit
# Configure Ten-GigabitEthernet 1/0/2 as a trunk port, and assign the port to VLAN 10.
[FCF] interface ten-gigabitethernet 1/0/2
[FCF-Ten-GigabitEthernet1/0/2] port link-type trunk
[FCF-Ten-GigabitEthernet1/0/2] port trunk permit vlan 10
[FCF-Ten-GigabitEthernet1/0/2] quit
# Enable FCoE for VLAN 10 and map VLAN 10 to VSAN 10.
[FCF] vlan 10
[FCF-vlan10] fcoe enable vsan 10
Verifying the configuration
# Display ENode information obtained by the Transit switch.
[Transit] display fip-snooping enode