H3C Technologies H3C S10500 Series Switches - Manual (Page 99)

88
Step Command
3. Activate a zone set as the active zone set and
distribute it to the entire fabric.
zoneset activate name zoneset-name
NOTE:
Active zone set information will not contain the alias names of zone members. If a zone in the active zone
set has members with a zone alias, the non-overlapping N_Port members in the zone alias are added to
the zone. You can view the zone member change by using the display zoneset active command.
Triggering a complete distribution
Use the zoneset distribute command to trigger a one-time complete distribution, which distributes both
the active zone set and zone database. In enhanced zoning mode, the zone policy and hard zoning
status are also distributed.
After activating a zone set as the active zone set by using the zoneset activate command, you can modify
the zone database configuration. The zoneset distribute command distributes the active zone set and the
modified zone database to the entire fabric without changing the active zone set.
If the distribution fails, the system prints a log message. In this case, perform a new distribution to ensure
zone data consistency across the fabric.
To trigger a complete distribution:
Step Command
1. Enter system view. system-view
2. Enter VSAN view. vsan vsan-id
3. Trigger a complete distribution. zoneset distribute
Renaming zone aliases, zones, and zone sets
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Rename a zone alias.
zone-alias rename old-name
new-name
The zone alias to be renamed must
have been created, and the new
zone alias must not have been
created.
4. Rename a zone. zone rename old-name new-name
The zone to be renamed must have
been created, and the new zone
must not have been created.
5. Rename a zone set. zoneset rename old-name new-name
The zone set to be renamed must
have been created, and the new
zone set must not have been
created.