H3C Technologies H3C S10500 Series Switches - Manual (Page 117)

106
Setting the FC-MAP value
The FC-MAP value identifies an FCoE network. Switches (including FCF switches and Transit switches) in
the same FCoE network must have the same FC-MAP value.
You can use the fcoe fcmap command to set the FC-MAP value in frames sent out of an FCF switch. You
can use the fip-snooping fc-map command to set an FC-MAP value for a VLAN on a Transit switch.
When an Ethernet interface in the FIP snooping VLAN receives a frame from the FCF switch, the following
rules apply:
• If the FC-MAP value in the incoming frame is the same as that configured for the FIP snooping VLAN,
the Ethernet interface forwards the frames.
• If the FC-MAP value in the incoming frame is different from that configured for the FIP snooping
VLAN, the Ethernet interface drops the frames.
To set an FC-MAP value:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VLAN view. vlan vlan-id N/A
3. Set an FC-MAP value. fip-snooping fc-map fc-map The default setting is 0x0EFC00.
Displaying and maintaining FIP snooping
Execute display commands in any view.
Task Command
Display ENode information obtained by a Transit
switch.
display fip-snooping enode [ vlan vlan-id ]
Display FCF switch information obtained by a Transit
switch.
display fip-snooping fcf [ vlan vlan-id ]
Display the FIP snooping rules that have been flushed
(in standalone mode). display fip-snooping rules [ enode | fcf ] [ vlan
vlan-id ] [ slot slot-number ]
Display the FIP snooping rules that have been flushed
(in IRF mode). display fip-snooping rules [ enode | fcf ] [ vlan
vlan-id ] [ chassis chassis-number slot slot-number ]
Display the FIP snooping rules that are being flushed.
display fip-snooping flushing-rules [ enode | fcf ]
[ vlan vlan-id ]
Display information about FIP snooping sessions
(connections between ENodes and FCF switches).
display fip-snooping sessions [ vlan vlan-id ]