H3C Technologies H3C S10500 Series Switches - Manual (Page 165)

154
# Bind VFC 11 to Layer 2 aggregate interface 2.
[SwitchA-Vfc11] bind interface bridge-aggregation 2
# Assign VFC 11 to VSAN 200 as a trunk port.
[SwitchA-Vfc11] port trunk vsan 200
# Enable FSPF for VFC 11.
[SwitchA-Vfc11] undo fspf silent vsan 200
[SwitchA-Vfc11] quit
# Enable FCoE for VLAN 4001 and map VLAN 4001 to VSAN 100.
[SwitchA] vlan 4001
[SwitchA-vlan4001] fcoe enable vsan 100
[SwitchA-vlan4001] quit
# Enable FCoE for VLAN 4002 and map VLAN 4002 to VSAN 200.
[SwitchA] vlan 4002
[SwitchA-vlan4002] fcoe enable vsan 200
[SwitchA-vlan4002] quit
# Enter the view of VSAN 100, and configure the members in the default zone to access each
other.
[SwitchA] vsan 100
[SwitchA-vsan100] zone default-zone permit
[SwitchA-vsan100] quit
# Enter the view of VSAN 200, and configure the members in the default zone to access each
other.
[SwitchA] vsan 200
[SwitchA-vsan200] zone default-zone permit
[SwitchA-vsan200] quit
Configuring Switch C
1. Configure the switch to operate in advanced mode, save the configuration, and reboot the switch.
(Skip this step if the switch is operating in advanced mode.)
<SwitchC> system-view
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the system
to make it effective.
[SwitchC] save
The current configuration will be written to the device. Are you sure? [Y/N]:y
Please input the file name(*.cfg)[flash:/startup.cfg]
(To leave the existing filename unchanged, press the enter key):
Validating file. Please wait...
Saved the current configuration to mainboard device successfully.
Slot 1:
Save next configuration file successfully.
[SwitchC] quit
<SwitchC> reboot
Start to check configuration with next startup configuration file, please
wait.........DONE!
Current configuration will be lost after the reboot, save current configuration?
[Y/N]:y