H3C Technologies H3C S10500 Series Switches - Manual (Page 62)

51
# Create interface VFC 1, and bind it to interface Ten-GigabitEthernet 1/0/1.
[SwitchB] interface Vfc 1
[SwitchB-Vfc1] bind interface ten-gigabitethernet1/0/1
# Configure VFC 1 to operate in E mode, and assign it to VSAN 1 as a trunk port.
[SwitchB-Vfc1] fc mode e
[SwitchB-Vfc1] port trunk vsan 1
[SwitchB-Vfc1] quit
# Create interface VFC 2, and bind it to interface Ten-GigabitEthernet 1/0/2.
[SwitchB] interface Vfc 2
[SwitchB-Vfc2] bind interface ten-gigabitethernet1/0/2
# Configure VFC 2 to operate in E mode, and assign it to VSAN 1 as a trunk port.
[SwitchB-Vfc2] fc mode e
[SwitchB-Vfc2] port trunk vsan 1
[SwitchB-Vfc2] quit
# Create interface VFC 3, and bind it to interface Ten-GigabitEthernet 1/0/3.
[SwitchB] interface Vfc 3
[SwitchB-Vfc3] bind interface ten-gigabitethernet1/0/3
# Configure VFC 3 to operate in E mode, and assign it to VSAN 1 as a trunk port.
[SwitchB-Vfc3] fc mode e
[SwitchB-Vfc3] port trunk vsan 1
[SwitchB-Vfc3] quit
# Permit members in the default zone to access each other. By default, the server and disk belong
to the default zone and members in the default zone are not permitted to access each other. For
more information about zones, see " Configuring FC zones ."
[SwitchB] vsan 1
[SwitchB-vsan1] zone default-zone permit
[SwitchB-vsan1] quit
3. Configure Switch C:
# Configure the switch to operate in advanced mode, save the configuration, and reboot the
switch. (Skip this step if the switch is operating in advanced mode.)
<SwitchC> system-view
[SwitchC] system-working-mode advance
Do you want to change the system working mode? [Y/N]:y
The system working mode is changed, please save the configuration and reboot the
system to make it effective.
[SwitchC] save
[SwitchC] quit
<SwitchC> reboot
# Configure the switch to operate in FCF mode.
<SwitchC> system-view
[SwitchC] fcoe-mode fcf
# Enable the fabric configuration feature in VSAN 1. By default, the fabric configuration feature is
enabled.
[SwitchC] vsan 1
[SwitchC-vsan1] domain configure enable
# Set the domain ID to 13.