H3C Technologies H3C S10500 Series Switches - Manual (Page 95)

84
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Create a zone alias and
enter its view.
zone-alias name zone-alias-name
If the zone alias has been created,
enter its view directly.
4. Add a member to the zone
alias. member { fcid fcid | fwwn fwwn |
pwwn pwwn } [ initiator | target ] By default, no member exists in a
new zone alias.
Configuring zones
You can specify members of a zone by using their FC addresses, pWWNs, fWWNs, or zone aliases. An
fWWN is the WWN of an F_Port. An F_Port member represents all N_Ports that log in through the F_Port.
A zone alias represents a group of N_Ports. N_Port members specified by using their FC addresses or
pWWNs can be indirectly connected to the switch. A member can belong to more than one zone.
You can specify the role of a member as an initiator, a target, or both when adding the member. The role
takes effect only after you enable the Pairwise feature.
To configure a zone:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Create a zone and enter
its view.
zone name zone-name
If the zone has been created, enter
its view directly.
4. Add a member to the
zone.
member { { fcid fcid | fwwn fwwn |
pwwn pwwn } [ initiator | target ] |
zone-alias zone-alias-name }
By default, no member exists in a
new zone.
Configuring zone sets
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Create a zone set (if the
zone set does not exist)
and enter its view.
zoneset name zoneset-name N/A
4. Add a zone to the zone
set.
member zone-name
By default, no zone exists in a new
zone set.