H3C Technologies H3C S10500 Series Switches - Manual (Page 96)

85
Configuring the default zone policy
In enhanced zoning mode, the switch distributes the default zone policy with other zone data. In basic
zoning mode, you must manually configure a consistent default zone policy across the fabric.
After the switch performs a zoning mode switchover, it also distributes the default zone policy with other
zone data.
To configure the default zone policy:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Permit members in the
default zone to access
each other.
zone default-zone permit Use one of the commands.
By default, default zone members
are not permitted to access each
other.
4. Deny members in the
default zone from
accessing each other.
undo zone default-zone permit
Configuring the zone distribution and merge type
Complete distribution (or merge) distributes (or merges) both the active zone set and zone database.
Incomplete distribution (or merge) distributes (or merges) only the active zone set.
This feature is supported only in basic zoning mode. In enhanced zoning mode, the zone distribution
and merge type is always complete, and this feature is not supported.
The configured distribution type applies to distribution operations triggered by the zoneset activate
command instead of the zoneset distribute command.
The configured merge type applies to all merge operations.
To configure the zone distribution and merge type:
Step Command Remarks
1. Enter system view. system-view N/A
2. Enter VSAN view. vsan vsan-id N/A
3. Configure zone
distribution and merge
types as complete.
zoneset distribute full The default setting is incomplete.
Configuring a merge control mode
Two merge control modes are available: Restrict and Allow. For information about these two modes, see
"
Zone merge in enhanced zoning mode ."