Verifying the configuration – H3C Technologies H3C SecPath F1000-E User Manual
Page 103
91
[RouterB] interface GigabitEthernet 0/1
[RouterB-GigabitEthernet0/1] ipv6 address 3003::1 64
[RouterB-GigabitEthernet0/1] quit
# Configure an IPv6 manual tunnel.
[RouterB] interface tunnel 0
[RouterB-Tunnel0] ipv6 address 3001::2/64
[RouterB-Tunnel0] source GigabitEthernet 0/2
[RouterB-Tunnel0] destination 192.168.100.1
[RouterB-Tunnel0] tunnel-protocol ipv6-ipv4
[RouterB-Tunnel0] quit
# Configure a static route to IPv6 Group 1 through Tunnel 0 on Router B.
[RouterB] ipv6 route-static 3002:: 64 tunnel 0
Verifying the configuration
After the above configurations, display the status of the tunnel interfaces on Router A and Router B.
[RouterA] display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:6401
Global unicast address(es):
3001::1, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:6401
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds
ND retransmit interval is 1000 milliseconds
Hosts use stateless autoconfig for addresses
IPv6 Packet statistics:
InReceives: 55
...
[RouterB] display ipv6 interface tunnel 0
Tunnel0 current state :UP
Line protocol current state :UP
IPv6 is enabled, link-local address is FE80::C0A8:3201
Global unicast address(es):
3001::2, subnet is 3001::/64
Joined group address(es):
FF02::1:FF00:0
FF02::1:FF00:1
FF02::1:FFA8:3201
FF02::2
FF02::1
MTU is 1480 bytes
ND reachable time is 30000 milliseconds