H3C Technologies H3C SecPath F1000-E - Manual (Page 206)

194
From the ACL list, select ACL 3101 and click the icon. Then, click Add to enter the ACL rule
configuration page and perform the configurations shown in
Figure 122 .
Figure 122 Configure a rule to permit packets from 10.1.1.0/24 to 10.1.2.0/24
• Select Permit from the Operation list .
• Select Source IP Address and enter 10.1.1.0 and 0.0.0.255 respectively in the following fields.
• Select Destination IP Address and enter 10.1.2.0 and 0.0.0.255 respectively in the following fields.
• Click Apply.
# Configure an IPsec proposal named tran1, and configure the proposal as follows.
Select VPN > IPSec > Proposal from the navigation tree, click Add, select Custom mode from the IPSec
Proposal Configuration Wizard page, and perform the configurations shown in Figure 123 .
Figure 123 Configure IPsec proposal tran1
• Enter tran1 as the name of the IPsec proposal.
• Select Tunnel as the packet encapsulation mode.