Configuring spoke 1 – H3C Technologies H3C SecPath F1000-E User Manual
Page 469
457
[Hub2-ospf-100-area-0.0.0.0] network 192.168.1.2 0.0.0.255
[Hub2-ospf-100-area-0.0.0.0] quit
# Configure OSPF for the private networks.
[Hub2] ospf 200
[Hub2-ospf-200] area 0
[Hub2-ospf-200-area-0.0.0.0] network 10.0.1.2 0.0.0.255
[Hub2-ospf-200-area-0.0.0.0] quit
[Hub2] ospf 300
[Hub2-ospf-300] area 0
[Hub2-ospf-300-area-0.0.0.0] network 10.0.2.2 0.0.0.255
Configuring Spoke 1
1.
Configure IP addresses for the interfaces. (Details not shown.)
2.
Configure the VAM client:
<Spoke1> system-view
# Create a VAM client named dvpn1spoke1 for VPN 1.
[Spoke1] vam client name dvpn1spoke1
[Spoke1-vam-client-name-dvpn1spoke1] vpn 1
# Specify the IP addresses of the VAM servers and set the pre-shared key.
[Spoke1-vam-client-name-dvpn1spoke1] server primary ip-address 192.168.1.22
[Spoke1-vam-client-name-dvpn1spoke1] server secondary ip-address 192.168.1.33
[Spoke1-vam-client-name-dvpn1spoke1] pre-shared-key simple 123
# Create a local user named dvpn1spoke1, setting the password as dvpn1spoke1.
[Spoke1-vam-client-name-dvpn1spoke1] user dvpn1spoke1 password simple dvpn1spoke1
[Spoke1-vam-client-name-dvpn1spoke1] client enable
[Spoke1-vam-client-name-dvpn1spoke1] quit
3.
Configure the IPsec profile:
# Configure the IPsec proposal.
[Spoke1] ipsec proposal vam
[Spoke1-ipsec-proposal-vam] encapsulation-mode tunnel
[Spoke1-ipsec-proposal-vam] transform esp
[Spoke1-ipsec-proposal-vam] esp encryption-algorithm des
[Spoke1-ipsec-proposal-vam] esp authentication-algorithm sha1
[Spoke1-ipsec-proposal-vam] quit
# Configure the IKE peer.
[Spoke1] ike peer vam
[Spoke1-ike-peer-vam] pre-shared-key abcde
[Spoke1-ike-peer-vam] quit
# Configure the IPsec profile.
[Spoke1] ipsec profile vamp
[Spoke1-ipsec-profile-vamp] proposal vam
[Spoke1-ipsec-profile-vamp] ike-peer vam
[Spoke1-ipsec-profile-vamp] sa duration time-based 600
[Spoke1-ipsec-profile-vamp] pfs dh-group2
[Spoke1-ipsec-profile-vamp] quit
4.
Configure the DVPN tunnel: