Configuring secpath b – H3C Technologies H3C SecPath F1000-E User Manual
Page 48
36
Figure 32 Adding a P2MP GRE tunnel interface (Tunnel 0)
4.
Configure a static route from SecPath A through interface Tunnel0 to the branch network:
a.
Select Network > Routing Management > Static Routing from the navigation tree.
b.
Click Add to perform the configurations shown in
c.
Enter 192.168.12.0 as the destination IP address.
d.
Select mask 255.255.255.0.
e.
Select Tunnel0 as the outbound interface.
f.
Click Apply.
Figure 33 Adding a static route from SecPath A through interface Tunnel0 to the branch network
Configuring SecPath B
1.
Configure an IPv4 address for each interface and assign the interfaces to security zones. (Details
not shown.)
2.
Create a P2MP GRE tunnel interface, with the tunnel interface number being 0:
a.
Select VPN > GRE > P2MP from the navigation tree.
b.
Click Add to perform the configurations shown in