Precision Digital PD6200 - Manual (Page 10)

Model PD6200 Analog Input Rate/Totalizer Instruction Manual
10
DECIMAL POINT Up to five decimal places or none:
d.ddddd, d.dddd, d.ddd, d.dd, d.d,
or
dddddd
CALIBRATION
RANGE Input
Range Minimum Span
Input 1 & Input 2
4-20 mA 0.15 mA
10 V
0.10 V
An Error message will appear if the input 1 and input 2
signals are too close together.
INPUT
IMPEDANCE Voltage ranges: greater than 1 M

Current ranges: 50 - 100

(depending on resettable fuse impedance)
INPUT
OVERLOAD Current input protected by resettable fuse, 30 VDC max.
Fuse resets automatically after fault is removed.
Rate/Totalizer
DISPLAY
ASSIGNMENT The main (Big) and small (Little) displays may be assigned
to rate, total, grand total, alternate R & T, units, and set
point.
RATE DISPLAY
INDICATION -99999 to 999999, lead zero blanking. “R” LED illuminates
while displaying rate.
TOTAL DISPLAY
& TOTAL
OVERFLOW 0 to 999,999; automatic lead zero blanking. “T” LED is illumi-
nated while displaying total or grand total.
Up to 999,999,999 with total-overflow feature. “
oF
” is dis-
played to the left of total overflow and
▲ LED is illuminated.
ALTERNATING
DISPLAY Either display may be programmed to alternate between
rate and total or rate and grand total every 10 seconds.
TOTAL
DECIMAL POINT Up to five decimal places or none:
d.ddddd, d.dddd, d.ddd, d.dd, d.d,
or
dddddd
Total decimal point is independent of rate decimal point.
TOTALIZER Calculates total based on rate and field programmable mul-
tiplier to display total in engineering units. Time base must
be selected according to the time units in which the rate is
displayed.
TOTALIZER
ROLLOVER Totalizer rolls over when display exceeds 999,999,999.
Relay status reflects display.
TOTAL
OVERFLOW
OVERRIDE
Program total reset for automatic with 0.1 second delay and
set point 1 for 999,999
TOTALIZER
PRESETS Up to eight, user selectable under setup menu. Any set
point can be assigned to total and may be programmed
anywhere in the range of the meter for total alarm indica-
tion.