Precision Digital PD6200 - Manual (Page 31)

Model PD6200 Analog Input Rate/Totalizer Instruction Manual
31
Display Parameter Action/Setting Description
RLY 2 Relay 2 Relays 2-8 setup
Note: Relays 5-8 are shown, only if ex-
pansion relay module is installed.
FaiLSF Fail-safe Enter Fail-safe menu
FLS 1 Fail-safe 1 Set relay 1 fail-safe operation
on On Enable fail-safe operation
off Fail-safe off Disable fail-safe operation
DeLAY Delay Enter relay Time Delay menu
DLY 1 Delay 1 Enter relay 1 time delay setup
On 1 On Set relay 1 On time delay
OFF 1 Off Set relay 1 Off time delay
break Loop break Set relay condition if loop break detected
(For mA input only)
iGnorE Ignore Ignore loop break condition
(Processed as a low signal condition)
On On Relay goes to alarm condition when loop
break is detected
OFF
Off Relay goes to non-alarm condition when
loop break is detected
Aout
Analog output Enter the Analog output scaling menu
Dis 1
Display 1 Program display 1 value
Out 1
Output 1 Program output 1 value (e.g. 4.000 mA)
Dis 2
Display 2 Program display 2 value
Out 2
Output 2 Program output 2 value (e.g. 20.000 mA)
T tb
Total time
base Program total time base
T CF
Total conver-
sion factor Program total conversion factor
T rst Total reset Program total rest mode: auto or manual
GT tb Grand total
time base Program grand total time base
GT CF Grand total
conversion
factor Program grand total conversion factor